These are digital hitec HS5925's, the control arms are currently 1.25" but I'm considering 1.5" arms to try to get some more throw, the distance from the hingeline to where the control-horn->pivot-point is 1.75" and thats as small as it can be since the elevator is airfoiled. By 'Pushing back', I ment how much force is deflecting the elevator going generage and 'push back' on the servo. Its nice to know that my servo has effective torque of around 250oz/in but thats meaningless unless I can figure out how much the elevator is going to torque the servo, no?

Thanks,
Sam