RCU Forums - View Single Post - Dave Patrick Edge 540T Stab Problem
Thread: Dave Patrick Edge 540T Stab Problem
View Single Post
Old 03-04-2004 | 04:30 PM
  #1  
Dannyrb
Junior Member
 
Joined: Jul 2003
Posts: 4
Likes: 0
Received 0 Likes on 0 Posts
From: Oxford, MS
Default Dave Patrick Edge 540T Stab Problem
Has anyone had a problem with the horizontal stab adjuster screws lining up with the slots in the stab adjuster rod ?

In comparing the placement of the horizontal stab adjuster screws with another Edge 540T, I found that my planes horizontal adjuster screws were 3mm further from the edge of the horizontal stab than the one that was assembled.

Has anyone else encounter this problem and what was the fix?
Dannyrb is offline  
Reply Like