RCU Forums - View Single Post - programming dual elevator servos
Thread: programming dual elevator servos
View Single Post
Old 06-12-2002 | 12:54 PM
  #3  
pmartjr
Member
 
Joined: Feb 2002
Posts: 51
Likes: 0
Received 0 Likes on 0 Posts
From: Dayton, OH
Default programming dual elevator servos
On the 8103, you have to inhibit the knob for Aux 3. Then go to the travel adjust program and set the travel of Channel 8 to match your master channel (Channel 3, Elevator) in both directions. That's it.
pmartjr is offline  
Reply Like