RCU Forums - View Single Post - programming dual elevator servos
Thread: programming dual elevator servos
View Single Post
Old 06-12-2002 | 01:07 PM
  #4  
bob_nj
My Feedback: (62)
 
Joined: Dec 2001
Posts: 3,857
Likes: 0
Received 0 Likes on 0 Posts
From: Vineland, NJ
Default Question
Assuming the geometry is equal on both halves, does setting the endpoints mean that any point in between will be the same deflection on either side?
bob_nj is offline  
Reply Like