RCU Forums - View Single Post - programming dual elevator servos
Thread: programming dual elevator servos
View Single Post
Old 06-15-2002 | 11:53 PM
  #14  
stickman/vic
My Feedback: (85)
 
Joined: Jan 2002
Posts: 59
Likes: 0
Received 0 Likes on 0 Posts
From: Johnson City, TN
Default elevator setup
The simplest way to do what you need is to use one JR servo on one side and one Hitec of the same speed and torque raring on the other side. Guess what, they move in opposite directions which works out just fine in this application. You need a "Y" connector of course. Vic Koenig
stickman/vic is offline  
Reply Like