RCU Forums - View Single Post - Push Rods
Thread: Push Rods
View Single Post
Old 06-15-2002 | 03:50 PM
  #1  
BlackHorsearegreat's Avatar
BlackHorsearegreat
Senior Member
 
Joined: Jun 2002
Posts: 185
Likes: 0
Received 0 Likes on 0 Posts
From: Liverpool, UNITED KINGDOM
Default Push Rods
Hello there.

As a total beginner to the hobby, I am just putting my 1st ARTF together. The Push Rod on the Elevators is slightly too long, but overly long to be just trimmed out.

The question is, what is the best way to put a new bend in the push rod? Is there a set way to do this with a tool or something, or just to go ahead and bend it?
BlackHorsearegreat is offline  
Reply Like