When I bought the Jetcat GPS last year there were no instructions with it. I have been running the system with a tele cable connected to the I/O board and connecting the GSU to the GPS, works fine.

I note that on my new V5 ECUs there is a plug marked GPS. There is also a plug on the GPS but no indication of polarity etc. on the case. Can I connect the GPS to thye ECU using these two plugs and if so what cable is required.

(My new P70 is peforming absolutely superbly in a Bobcat XL and gives almost 10 minutes flying time on the fuel available, landing with a half full fuselage tank ).

Regards, David Gladwin