Good news and bad news.

Last night I started the kit, it was 12 AM and late, so I was tired but I can never get to sleep, I cut out all the fuz parts and it was alot of fun. Much more fun than an ARTF! Anyway, I cutted them all out, looked through plans and instructions etc, then sandwiched glued ALL the wing bolt plates togther, yes, I f***** it up, already.

So I can't cut them apart, the epoxy is too strong, Ive broken 3 blades trying, I can't make more, I don't have th recources.

The only option I can think of is ring up and pay them some money to send me the sheets with the WB plates, I can't buy whole fuz kit just for those plates.

I knew what I had to do! I guess cause it was 1:30 AM I was not thinking straight....

Anyway, I started on what I could of the fuz by using a bare kitchen table and apples to weigh the plan down, this is amazing! Everything clicks in just fine! As soon as I get those plates sorted I can get the fuz over and done with.

Excellent kit but I'll need some help.

If IH won't send me the plates, I will have to get someone to make 'em, anyone???