RCU Forums - View Single Post - Setup/Mods to Kyosho Flip 3D
View Single Post
Old 06-01-2004 | 01:36 PM
  #4  
Ian.W's Avatar
Ian.W
Senior Member
 
Joined: Jun 2003
Posts: 4,285
Likes: 0
Received 0 Likes on 0 Posts
From: Essex, UNITED KINGDOM
Default RE: Setup/Mods to Kyosho Flip 3D

erm, this isnt really a tip of anything, but id seariously advise not carshing it!

also, this is a tip, add a strong servo to the tail, thats one hell of a lot of rudder. i only had a 148, which i admit worked ok but it got allot of slop very quick, so i changed it on sun morning to a new 148 and that wernt a good move, on a little tumble about 25 foot up it when into n inv spin and doinked itself on the deck. at center stick the rudd had about the same amount of movement as in the picture, so i coulnt pull out in time. hit the deck not too hard but totaled it, in that mid canopy section there were no formers left, and allot of dust! lol