I'm to the point on the construction of my Knife ARF where I'm to install the radio, battery and fuel tank into the wing. The instructions say to install them and make sure they don't move around. I've built quite a few kits and I'm pretty good at making modifications to keep the reciever and battery in place. However, I can't figure out how to do it in the wings of this plane. If I install the receiver now, and then install the servo tray after it I won't be able to plug all the servos into the reciever.. I've tried to keep them from moving, but I klnow this won't work.. how did everyone else do this????

Can anyone help???