RCU Forums - View Single Post - Rudder servo pull-pull installations
Thread: Rudder servo pull-pull installations
View Single Post
Old 12-06-2004 | 06:43 PM
  #5  
Bob Pastorello's Avatar
Bob Pastorello
My Feedback: (198)
 
Joined: Feb 2002
Posts: 6,707
Likes: 0
Received 0 Likes on 0 Posts
From: El Reno, OK
Default RE: Rudder servo pull-pull installations
Note the servo arm end...it has the takeoff points slightly aft of the centerline of the output shaft, thus introducing the Ackerman needed....(great thread recently on this topic on the NSRCA mailing list)

VERY nice install, Peter!!
Bob Pastorello is offline  
Reply Like