RCU Forums - View Single Post - Tensor 4D setup
View Single Post
Old 01-01-2005 | 09:28 PM
  #3  
Culverson's Avatar
Culverson
Senior Member
My Feedback: (14)
 
Joined: Aug 2002
Posts: 1,372
Likes: 0
Received 0 Likes on 0 Posts
From: Jasper, AL
Default RE: Tensor 4D setup

George reccomends the Eflite 1080 Mv outrunner, I used the Eflite 1360 Mah motor which far exceeded my expectations to say the least.. The 1080 would be the choice with lower Mah packs (longer flight times) & keeping your planes weight down (wing loading lighter)
With prices like these brushless flight is being made very affordable for everyone..[8D]

I like the Eflite moto because it comes with the bullet gold plated connectors (pre-installed) the X motor mount the prop adapter all included for roughly $49.99..Lot of bang for the $$..Performance is great..Hovers around half throttle..I used a Phoenix CC 25, but Eflite makes a 20A ESC (BL) very reasonably priced..LHS had one for $40.00-$41..Nice ESC..
[link]http://www.horizonhobby.com/ProdInfo/EFL/250/EFLA311-250.jpg[/link]

Continuous Maximum Current: 20A
Dimensions: 1.4x.95x.37 in (36x24x9 mm)
Weight: .5 oz (14 g)


CC Phoenix 10
0.21 oz. (6g)