Hi everyone!

Just arrived at my doorstep today!

The wing panels and tail feathers are built-up and very light. The construction, covering job, paint work, and quality of wood are excellent! The hinges are already installed and ready for CA. The blind nuts for the landing gear are installed, as well. There are strings through the wings to make the servo cabling easy. The decals have already been applied!

A few complaints, though... the wheel pants are of the rubber ducky variety (no problem I'll use the 1.20 size Cap pants I just got from Hangar-9 by accident), the tail group does not use an airfoil, and the control surfaces are not double beveled (I'll make a 1/16" gap and seal the hinges for more throw). Assembly looks painless, however. Should have it done by the end of next week. You can follow the progress on my website.