RCU Forums - View Single Post - mvvs 160 gasser for 3D
View Single Post
Old 09-12-2002 | 02:13 PM
  #9  
Welsh3D
Senior Member
 
Joined: May 2002
Posts: 1,140
Likes: 0
Received 0 Likes on 0 Posts
From: Chester, UNITED KINGDOM
Default mvvs 160 gasser for 3D

prop is an APC 16x8..... I preferred Mejzlik but damaged an end of that prop following a wheel locking up taxying- bit of a shame really as the damage was incredibly small, but i think too much to make it usable.


Should be fine...... i'm using the spoileron mix..... hopefulyl with hat on permanently during the harrier it will be even more steady.