Hi all,

I am a newbie at this so please save the laffs for later! I have a Ready 2 trainer which I want to fit one of those smart fuel fillers from Dobro. trouble is I don't have enough information to finish the job!

Please see my schematic here: http://home.clara.net/chris-while/RC/Drawing1.jpg

This is currently where I am at. I can't quite figure out how I connect the fuel filler and the feed from the tank to the carb! I'm sure this is an easy one, please save the tomatoes until I get her into the air (and keep it there for more than a minute!)

Thanks all

Chris