RCU Forums - View Single Post - 1st Time Using Point Hinges = LARGE Gap
Thread
:
1st Time Using Point Hinges = LARGE Gap
View Single Post
02-27-2005 | 08:35 PM
#
2
d_bodary
My Feedback: (
85
)
Joined:
Apr 2004
Posts:
1,533
Likes: 0
Received 1 Like on
1 Post
From:
trenton, MI
RE: 1st Time Using Point Hinges = LARGE Gap
sand your hinge line so the surfaces close up around the pin. where the hinges go not the whole hinge line.
hope this helps
Reply
Like
d_bodary
View Public Profile
Send a private message to d_bodary
Find More Posts by d_bodary
View iTrader Profile
RE: 1st Time Using Point Hinges = LARGE Gap