RCU Forums - View Single Post - Servo Size in a Sledge??
Thread: Servo Size in a Sledge??
View Single Post
Old 03-05-2005 | 05:56 PM
  #1  
Doug Brindle
Senior Member
My Feedback: (1)
 
Joined: Jan 2002
Posts: 100
Likes: 0
Received 0 Likes on 0 Posts
From: GREENWOOD, IN
Default Servo Size in a Sledge??
Hi Guys,
I'm building a Sledge right now. Using a Saito 72 in the nose. Any recommendations on servo size? Are 40 inoz servos OK to use in a typical 3D profile? I've been flying 1/3 giant Extra's and Edges, using digitals throughout... I'm not too sure about the 3D birds though.

thanks in advance for the advice.

The wing will be finished tonight, will start working on the fuse and tail in the morning.
-Doug Brindle
Doug Brindle is offline  
Reply Like