RCU Forums - View Single Post - BME 110x problems
View Single Post
Old 03-19-2005 | 12:27 AM
  #26  
RTK's Avatar
RTK
My Feedback: (1)
 
Joined: Apr 2003
Posts: 4,890
Likes: 0
Received 0 Likes on 0 Posts
From: Left Coast , CA
Default RE: BME 110x problems

Maybe I don't remember well and I know there are variances in the props from the same manufactures, but I believe my first run of my 110 on a 3w 26x10 hit 7000+ on the first run and I had richened the high about 1/4 even before trying to start it. Again this was with a warmed engine and only a 5 second burst. I could be all wet but you know how your memory goes with age.[]

ORIGINAL: mglavin
Was there any confusion on which needle was the high and low needle?

6600rpm with a 3W 26x10 is working a new engine way to hard IMO...
edited my original rpm #', found the paper I wrote my original run on.