Well im back again, this time ive fixed my fuel tank problem and bought 2 quarts of towerpower 10% for my .46 TowerHobbes engine... well lol, it still wont run.. if i prime the carb it will run for 30-40 seconds at full throttle, nothing but full... after that it will simply slow down then stop, ive adjusted the needle valve 4 1/2 out, 3 1/2 out, and all around inbetween, if anyone has a manual for this engine that would be nice too! So any info. you can give me? I've included a pic of the carb setup below, there is only one screw on the other side and its right above the linkage for the throttle servo, its all the way in...

.46 is the only engine on towers site w/o a manual, lol my luck...