RCU Forums - View Single Post - Priming problems?
View Single Post
Old 05-16-2005 | 05:42 PM
  #9  
Skynyrd Man's Avatar
Skynyrd Man
Senior Member
 
Joined: Feb 2005
Posts: 393
Likes: 0
Received 0 Likes on 0 Posts
From: Amherst, WI
Default RE: Priming problems?

I give up, as far as I'm concerned Tower can shove this thing where the sun don't shine[:@][:@][:@]
I have blown every thing out, I have reseated the carb twice. The O ring looks fine. I replaced all of the fuel lines. I shortened the brass tubes in case of pinching.
I have waisted to much of my time on this engine. I have had 3 crashes because of it. Luckily only one caused minor damage. I am putting an Evolution in it.
To bad I'm not one of those jerks who sell things "like new" on Ebay.
I don't know, will see what Tower says tomorrow.[>:]