Hi Guys,
I've been trying to do consistent torque rolls for a few years now, and I have gotten to the point where I can set it up consistently and even get through one roll ok. In the sim I can get through two or three torque rolls and I even hit four one time, but it always seems to wobble and fall apart after about two. What is the secret to getting a continuous torque roll? I'm using a Global Freestyle and I just put a Magnum 108 on it but I haven't gotten the motor broken in and reliable yet so I haven't tried a torque roll with it yet, but with the YS 63 I had on it I had enough power to torque roll and even pull out slowly. I'm thinking that all my rates are too high because the more I correct the worse it gets. What is a good amount of rates? My elevators each have one servo and they move 90deg total throw, the rudder is at max throw, about 70 deg total throw. I'm thinking I should use a lower rate for torque rolls. -Tom