RCU Forums - View Single Post - Building a Laser3D
Thread: Building a Laser3D
View Single Post
Old 01-20-2003 | 10:10 PM
  #158  
Iflyit
My Feedback: (512)
 
Joined: Jan 2002
Posts: 493
Likes: 0
Received 0 Likes on 0 Posts
From: Zebulon, NC
Default Building a Laser3D
No, I didnt sand them at all. it will fit up against the top, but then the leading edge wont be quite centered where the dowel will go, so I guess I will just put them in a little bit lower.
Iflyit is offline  
Reply Like