RCU Forums - View Single Post - Cutting prop driver key-way
Thread: Cutting prop driver key-way
View Single Post
Old 09-19-2005 | 02:23 AM
  #11  
Willdo
Senior Member
 
Joined: Jul 2003
Posts: 502
Likes: 0
Received 0 Likes on 0 Posts
From: Auckland, NEW ZEALAND
Default RE: Cutting prop driver key-way
I agree with FLYPAPER, that is a good cheap method and works really well in aluminium.
Making sure the tool is at the correct centre height ( centre of the bore ) is important, also make sure the chuck can't move at all!
Willdo is offline  
Reply Like