RCU Forums - View Single Post - Building a Sig 4*40....please support
Thread: Building a Sig 4*40....please support
View Single Post
Old 10-08-2005 | 02:37 PM
  #28  
sdcranford
My Feedback: (4)
 
Joined: Jun 2005
Posts: 305
Likes: 0
Received 0 Likes on 0 Posts
From: Nixa, MO
Default RE: Building a Sig 4*40....please support
Just sand it, I wouldnt waste the time removing it. You said it was about 1/64th. 1/64th off a 1/4 or 3/8 piece
of balsa is not going to hurt it. 80 grit should make quick work of the 1/64th of balsa.
sdcranford is offline  
Reply Like