I dinged my Shogun V2 and bent the shaft. I got a new one and replaced it and now I can't get the blades to track.

One or the other is always about 1 inch high and when I adjust the link for the higher or lower one even a half turn the other one trades places and they are still about an inch apart.....until 100% throttle that is.

At 100% the low one seems to jump up and it is now in track, lower the collective even a couple of clicks and they are again an inch apart.

The head and collective hardware are pretty sloppy but they were that way when it was new.

I tried for over an hour to get it in track and finally gave up.

Any suggestions would sure help.

Ron