Fellas... Just got my 10X in today and need some help with programming my Giant Scale U-Can-Do 3D.
The UCD has 4 Ail servos. What I'm trying to do (if possible) is mix in all 4 servos for regular flight but have a method whereby I can use the right side trim on the 10X to allow the flaps to raise/lower for harriers & other 3D stuff.
FYI, I'm using JR 4735 Servos all around and UCD is powered by Saito 180 swinging 18x6W APC. I've flown the heck out of the plane this summer with a 9303 but I never bothered to see if I could program it to do what I wanted. I was using a matchbox previously. Is this possible or do you fellas have any suggestions?
Thanks Guys!