I just recived my Blade CX yesterday and followed the directions for pre flight and first flight. I went through the first pack with no problems. I trimmed and adjusted what need to be adjusted. Today when I went to fly it again I followed the same procedure for connected the battery and letting the control module initialize. As soon as the control modual initialized this time the servos started jittering rapidly. The blades would spin for a quick second without the throttle or trim being touched. I put the heli on the floor and got it into a hover and when I try to rotate the tail in either direction the heli looses all power and drops to the ground. I unpluged and checked all the wires and even tried a second battery pack but the same thing keeps on happening. Any one have any ideas? Can the 4in1 contorl module be bad? This is my first Heli so any help is appreciated.