Converting T-IFO to Elevons
02-29-2004 | 02:17 PM
#1
Thread Starter
Junior Member
Joined: Feb 2004
Posts: 14
Likes: 0
Received 0 Likes
on
0 Posts
From: Belmont,
NC
Converting T-IFO to Elevons
I have a new T-IFO I've been flying with Rudder and Elevator.
What differences are there flying with Elevons?
Is it just more responsive or very unstable?
I'm using an old Hitec Focus 6 radio which doesn't have mixing with a Berg4 receiver, Pixie 7 ESC and Hitec 55 servos, Lipoly 860 battery.
Can I use a GWS $14 mixer with this for elevons?
If I do how much travel should I set for aileron and elevator?
The Focus 6 does have electric end point adjustment.
Thanks in advance-off to fly it again (wind permitting).
Thanks in advance.
Don
What differences are there flying with Elevons?
Is it just more responsive or very unstable?
I'm using an old Hitec Focus 6 radio which doesn't have mixing with a Berg4 receiver, Pixie 7 ESC and Hitec 55 servos, Lipoly 860 battery.
Can I use a GWS $14 mixer with this for elevons?
If I do how much travel should I set for aileron and elevator?
The Focus 6 does have electric end point adjustment.
Thanks in advance-off to fly it again (wind permitting).
Thanks in advance.
Don
03-07-2004 | 09:13 PM
#2
Senior Member
Joined: Oct 2002
Posts: 100
Likes: 0
Received 0 Likes
on
0 Posts
From: Menominee, MI
RE: Converting T-IFO to Elevons
Don
Go to WildRC.com and click on support, and just about all your questions will be answered.
They even tell you how to change your T-IFO to use elevons.
Good Luck
Ralph V.
Go to WildRC.com and click on support, and just about all your questions will be answered.
They even tell you how to change your T-IFO to use elevons.
Good Luck
Ralph V.
