Hey, I was thinking of getting a VPP set from Hobby-lobby and get the axi motor with it, then get a Pheonix 10 brushless esc and have a 2 cell 1320maH li po along with a jr XF631 (6 channel) an Jr R610M reciever all in a reach Whirlwind ( http://www.reach-model.com/products_0.htm ) do you think this would work ok (i would also use jr micro servos)

Thoughts???

Maidin

does anyone know if this would work ok?? or else wot you would recomend

depends what model?. checkout my post on IKARUS VPP, much lighter than a 2208...

You will need a 3 cell battery for out VPP system. If the plane weighs 10 ounces or less you'll have a blast.

Jason
Hobby Lobby Asst Sales Mgr

I'm using a reach Whirlwind picture below it can be found at http://www.reach-model.com/products_0.htm.

Also how much performance could you get from a 2 cell 1350mah lipo??

u will need a Phoenix 25 ESC...a 10 is not enough for that motor...i have the same set up on a Lee Ulinger Foamtana with a 3 cell 1050 duralite pack...insane power for indore and inverted hovers r very stable

A 10 Amp controller will be fine for the 2208/34 motor. We run the Jeti 8 Amp controllers with them. You really will need the 3 cell battery though.

Jason
Hobby Lobby Asst Sales Mgr

an axi would work just fine (a 2208/34 its built for that, kinda)