I maidened my Tensor 4d.
09-29-2006, 09:30 PM
#1
Senior Member
Thread Starter
Join Date: Mar 2006
Location: San Diego,
CA, AMERICAN SAMOA (USA)
Posts: 502
Likes: 0
Received 0 Likes
on
0 Posts
I maidened my Tensor 4d.
I just flew my tensor 4d and it was great. I think it flew way better than my GP reflection.
I ran on 900 3cell 12C impulse pack( 2 packs other was 910 3S kokam) and a rimfire 22M-1000 motor. Basically, I used all the stuff from my flatout.
With this one, aileron turns were very easy, hovers very nice, torque rolls were a snap!
The plane is very nice, however, there is a weakness in the tail section- I reinforced it.
Hardware was way better than flatout too!
I suggest buying this one right away, instead of a flatout or anything like that...
Do you have one?
Paul
I ran on 900 3cell 12C impulse pack( 2 packs other was 910 3S kokam) and a rimfire 22M-1000 motor. Basically, I used all the stuff from my flatout.
With this one, aileron turns were very easy, hovers very nice, torque rolls were a snap!
The plane is very nice, however, there is a weakness in the tail section- I reinforced it.
Hardware was way better than flatout too!
I suggest buying this one right away, instead of a flatout or anything like that...
Do you have one?
Paul
