i would like to know how to do a inverted flat spin

can anyone draw me a simple diagram of the stick position

and how do i got about entering a flat spin

any help would be great thanks

The way I do it is to climb up about 300', cut the throttle, nose over & dive toward the ground, give right rudder, left aileron & down elevator all @ the same time, after the plane makes about three spins throw your aileron to the right & it will go into an inverted flat spin, once in the flat spin on some planes you can ease the ailerons back to neutral & throttle up a little to increase the speed of the spin. Not all planes will do a good inverted flat spin. I have a sig profile ultimate that does great flat spins & I also have a 1/3rd scale pitts that will only make about two spins & it just stops spinning & falls, still inverted. You can use the same move with up elevator for an upright flat spin.
Good luck
Gil

Well thank you Gil
i am praticing on Flight model simulator with a great planes ucan do .60
and it works[>:]

i love it i am going to be getting my first aerobatic plane for christmas.
i have been wanting to take the next step up in flying to the wonderful world of aerobatics

thank you very much for your reply

Cheers
Bridi

oh by the way an chance you can explain to me on how to hover or is their a book out called hovering for dummies

Hey Bridi
Check out Nathan site here for 3D manoeuvers > http://www.3drc.info/aerobatics/3d/index.htm

If you enjoy his site tell him so here >
http://www.3drc.info/suggestions.htm

Hope this helps.