being a newbie to hardcore 3D I still get a kick out of knife edge to a hover

keep watching John and Ryans videos and learning

1 roll right virtical DL, then 1 roll left straight into blender, then into waterfall into a TR just off the deck.

I have been practing this one for a few weeks now and can now do it very well, that is until today when i went into the blender i lost control ( someone in the pits turned on, on my frequency!) Went into failsafe and did a blender into the deck Surprisingly only the front of the fus was damaged!!

Oh well, i'll try again next week

Andy

A straight rolling elevator to knife edge out near the deck. If you keep the plane level and straight as it falls it looks sweet as hell!! Your roll rate will vary with aileron throw and size, and how well your plane rolls from prop wash. I do these with a sledge 540 ,blue-head TT .61 and 13-6 prop. I can't get enough of this move. The sledge falls really slow in this maneuver so it looks really neat. I picked this trick up from the 3dbatix website. I think the Pilots name is Zak west. Way cool video of him doing a rolling elevator with an Extra.(I think) I just added a knife edge out at the end to compliment the trick. It took a whole lot of simulator time for me to get this one down.a whole lot of simulator time for me to get this one down.

My favorites are rolling harriers, torkrolls, blenders, and tipspins.

Oh, did I mention waterfalls?

3D-kid330

My other favourite, is putting my airplane back in the truck/trailer without any damage,after a having a near perfect day at the field....