Has anyone has a problem running the antenna wire down the fuse and out the tail? When I did that I get about 10 feet on a range check before it starts going crazy. I pulled the wire out and got it away from the servo's in the tail and it range checked good. But anytime I get the wire near the servo's goes back to being bad. What is the best way to route the wire and is it normal for servo's to interfere like that?

Thanks

Jimmy

Try routing the antenna out the top rear turtle deck just behind the canopy and tying off on top of the rudder.


HTH

Had a similar problem on the Laser3D. Is your actual RX within 3-4 inches of a servo? That's what caused my problem.

well i routed the antenna line up like described and flew it a few times before the horizontal stab ripped off in mid-air and it crashed into the ocean. so a new plane will fix my problem. thanks for the help though.

Jimmy

Oh Man!
Sorry to hear that Jimmy