Hi Guys,

I have just ordered from Austria (www.lindinger.at) a trainer for 3D, called Acromaster 3D .
I have a O.S. .91 engine. for this plane. The details are given below. Could you suggest a propeller for this set up.
( I have tried O.S.'s web site, they advised me to contact to the plane's manufacturer. )


Technische Daten:
Wingspan: 1580 mm; Length: 1630 mm; Weight: 3200 g; Engine 2T : 10 cm³;4T : 15 cm³

Thank you for your inputs in advance.

Regards.

Zafer

I would suggest a 12x6 APc or a 13x4W APC. Personally I would choose the 13x4W APC.

Your 2 to 3 inches out on diameter. 15x6 would be best. It is not a fun fly, you will need some speed.

What do you think about 14x6 APC.? Thou it is a bit costly.

Zafer

Too late to worry about cost now, you have ordered the plane

14x6 is ok.

Hi,

Finally I got my Hype Acromaster 3D finished . Hopefully I will go to the field tomorrow and after break in I will try to fly the plane.

Set up is O.S. 91 fx ( inverted) hitec 635 hb servos in rudder and elevator, 475 in ailerons and throttle. Hitec receiver and 6 V batt. I am still waiting my perry pump and on board glow to arrive. ( I think I will add them later).

I am not waiting to much from this plane since this is my first all-round trainer. In a year I have flown and crashed trainers and spads. But still I am a little bit nervous.

Wish me a good luck.
Regards.

Zafer

Hi again, I forgot to put the photo.
Zafer