Prop for U CAN DO 3D with 0.75 Engine
08-13-2004 | 09:23 PM
#1
Thread Starter
Junior Member
Joined: Jan 2003
Posts: 12
Likes: 0
Received 0 Likes
on
0 Posts
From: Lindenwold,
NJ
Prop for U CAN DO 3D with 0.75 Engine
I have U CAN DO 3D with Tower Hobbies 0.75 on it.
It does not pull from vertical.
what would be the best prop size for 3D
Thank you.
It does not pull from vertical.
what would be the best prop size for 3D
Thank you.
08-13-2004 | 11:21 PM
#2
Senior Member
Joined: Jul 2004
Posts: 172
Likes: 0
Received 0 Likes
on
0 Posts
From: stone mountain,
GA
RE: Prop for U CAN DO 3D with 0.75 Engine
which size UCD do u have thye .46 or the .60. I have the .60 size and i use the 15x4 wide prop. It pulls out of everything that you do on it
08-13-2004 | 11:24 PM
#3
Member
Joined: Mar 2004
Posts: 85
Likes: 0
Received 0 Likes
on
0 Posts
From: Durand,
MI
RE: Prop for U CAN DO 3D with 0.75 Engine
I have a Goldburg extreme 330 profile with a .75 Tower on with a 12 1/4 X 3 3/4, instant throttle response, pulls verticle out of sight and hovers at 3/8 throttle and weighs 5 1/4 lbs. I use 10% nitro omega fuel and it turns 14800 RPM's on the ground.
