elevator servos
12-22-2004 | 07:23 AM
#1
Thread Starter
Member
Joined: Jun 2004
Posts: 74
Likes: 0
Received 0 Likes
on
0 Posts
From: gliwice, CO, POLAND
elevator servos
I`m planning to bulid 3D plane such as 3W xtra-fun of Funtana 140. I want to put 2xHS-225MG on elevators. Would that be enough?
I`m going to use 6V.
I`m going to use 6V.
12-22-2004 | 09:23 AM
#2
Senior Member
Joined: Oct 2004
Posts: 904
Likes: 0
Received 0 Likes
on
0 Posts
From: Mullingar, IRELAND
RE: elevator servos
I work that out to be just under 5kg/cm. Prob be ok with 2 but you may want something a bit stronger.
If you want a mini why not try two JR 9411. Metal geared and you get virtually 6kg/cm torque on 4.8V
These are really good servos.
Angus
If you want a mini why not try two JR 9411. Metal geared and you get virtually 6kg/cm torque on 4.8V
These are really good servos.Angus
12-22-2004 | 02:13 PM
#3
Senior Member
My Feedback: (16)
Joined: Mar 2002
Posts: 1,066
Likes: 0
Received 0 Likes
on
0 Posts
From: Medford,
NJ
RE: elevator servos
The 225's are LOUSY servos. I have two of the 225MG's and they center lousy and hold lousy. You would be much better off with a standard futaba 3004, forget the specs the 3004's have more holding power.
Personally, for a strong, light, cheap servo I'd use a Hitec 5475 digital for $35 or the plain old hitec 475 for only $18.
Trust me, the 225's are junk [:'(]
Personally, for a strong, light, cheap servo I'd use a Hitec 5475 digital for $35 or the plain old hitec 475 for only $18.
Trust me, the 225's are junk [:'(]
