Madness C Of G Madness!!!!
#1
Thread Starter
Junior Member
Joined: Mar 2003
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
From: Hull, UNITED KINGDOM
Hi all
I'm just setting up my Madness and in the single sheet of instructions it gives the C of G as 200mm back from the leading edge. From what i've read most have it 37 to 38 percent and I work 200mm as being about 42 percent has anyone else tried it this far back.
TIA
Regards
Mike
I'm just setting up my Madness and in the single sheet of instructions it gives the C of G as 200mm back from the leading edge. From what i've read most have it 37 to 38 percent and I work 200mm as being about 42 percent has anyone else tried it this far back.
TIA
Regards
Mike
#2
Senior Member
Joined: Nov 2001
Posts: 2,065
Likes: 0
Received 0 Likes
on
0 Posts
From: The Woodlands,
TX
I can't tell you where my CG is on either my Flip or Madness, I don't measure that stuff. I fly the plane, and make adjustments until it flys the way I want it to fly. Here is hint, most all my planes, I need to push down elevator to land them, thats how far back the CG is. Most people pick up my planes and are amazed how far back it is.
#3
Senior Member
see the review under articles at www.rcaerosport.com
One of the reviewers has a CoG point there.
One of the reviewers has a CoG point there.
#4
Senior Member
Joined: Mar 2003
Posts: 342
Likes: 0
Received 0 Likes
on
0 Posts
From: blender land, UNITED KINGDOM
hi miker
i fly my madness at 180mm wich i find perfect for this set up,it will spin flat on rudder with only slight aileron correction.
good luck.
i fly my madness at 180mm wich i find perfect for this set up,it will spin flat on rudder with only slight aileron correction.
good luck.



