U-CAN-DO-3D *46 SIZE WITH A.61 EVOLUTION?
05-16-2010, 11:39 PM
#1
Senior Member
Thread Starter
Join Date: Jun 2008
Location: Miramar,
FL
Posts: 131
Likes: 0
Received 0 Likes
on
0 Posts
U-CAN-DO-3D *46 SIZE WITH A.61 EVOLUTION?
My friend is selling his u-can-do 3D 46 size but i sold all my small engines i swicht to gasonile the smalest i have is a 61 evolution and i was wondering what do u guys think this plane with a 61? im looking for 3D so ofcure i will need to move the batterie back but just in general what do you guys think>? check this video out the guy is flying with a 61 super tiger wich is heavier than the evolution ! thank you http://www.youtube.com/watch?v=-wXDutTX_RQ
05-17-2010, 03:57 AM
#2
Senior Member
RE: U-CAN-DO-3D *46 SIZE WITH A.61 EVOLUTION?
Thay should work out fine, a 40 size engine will be to small for real 3-D anyway. I am going to use a .91 fs in mine when I get to assemble it.
05-18-2010, 10:22 PM
#5
Senior Member
Thread Starter
Join Date: Jun 2008
Location: Miramar,
FL
Posts: 131
Likes: 0
Received 0 Likes
on
0 Posts
RE: U-CAN-DO-3D *46 SIZE WITH A.61 EVOLUTION?
haha thank you awsome! 
and what happen if i renforced the plane for speed with the 61? where can i renforced the wings and how?
and what happen if i renforced the plane for speed with the 61? where can i renforced the wings and how?
05-19-2010, 09:26 PM
#7
RE: U-CAN-DO-3D *46 SIZE WITH A.61 EVOLUTION?
Flutter is the issue. You can use good servos ,seal your hinge line, but the best thing you can do is only use full throttle on vertical up lines and not in level flight or down lines
