RCU Forums - View Single Post - flater finish & panel lines
Thread: flater finish & panel lines
View Single Post
Old 04-02-2006 | 09:07 PM
  #14  
Pa-18cub150's Avatar
Pa-18cub150
 
Joined: Nov 2005
Posts: 494
Likes: 0
Received 0 Likes on 0 Posts
From: ainsworth, NE
Default RE: flater finish & panel lines
I didn’t think about scuffing the UC before I started drawing the panel lines? I guess I will have to start over. Thanks for the advice I would have been upset when the Luster Kote pealed
Pa-18cub150 is offline  
Reply Like