I took the inline filter off, thinking that might be it, didnt help. I turned the needle(low) to where it would start then had to turn the high speed in to where it was about 1/2 turn out just to get 6200 on a 22x10 prop but it wouldnt idle because low end too rich, so i turned the low in until it would barely idle, now it wont start again unless i prime it thru the carb. I checked the diaphram in the carb, everything looks good there.LOL, Im kinda missing my ole reliable G-62 now, it didnt have as much low end power but atleast it would start on the 2nd flip. anymore suggestions? Thanks