RCU Forums - View Single Post - Designing a .60 size 3D'er
Thread: Designing a .60 size 3D'er
View Single Post
Old 07-07-2006 | 06:03 PM
  #14  
AeroDave's Avatar
AeroDave
Senior Member
 
Joined: Nov 2002
Posts: 1,706
Likes: 0
Received 0 Likes on 0 Posts
From: Lewiston, ID
Default RE: Designing a .60 size 3D'er
Better. just make sure they have double bevels for 3D throw As I'm sure you know, but just for other folks who might read this, the size of the control surfaces usually used for 3D limits usable top speed without flutter.
AeroDave is offline  
Reply Like