RCU Forums - View Single Post - How Do I set the Blade Tracking on The CX
Thread: How Do I set the Blade Tracking on The CX
View Single Post
Old 09-16-2006 | 09:37 PM
  #2  
jltray
Member
 
Joined: Jan 2003
Posts: 61
Likes: 0
Received 0 Likes on 0 Posts
From: Winston, GA
Default RE: How Do I set the Blade Tracking on The CX
If the lower blades do not spin on the same plane, there could be a couple of reasons.

1. Blades, if you replace them replace them in pairs and notice the VERY little number in the circle. Make sure they match.
2. Could be the swash plate is coming apart, press it back together.

If you have a vibration it could cause this also.

Let us know what you find.
jltray is offline  
Reply Like