RCU Forums - View Single Post - Returning digital servos to default
Thread: Returning digital servos to default
View Single Post
Old 09-30-2006, 09:07 PM
  #1  
drifter
My Feedback: (53)
 
drifter's Avatar
 
Join Date: Sep 2002
Location: Baltimore, MD
Posts: 548
Likes: 0
Received 1 Like on 1 Post
Default Returning digital servos to default
I have a couple of Hitec 5645 servos that have ben slowed down by their previous owner to use as retract servos. Is there any provision for returning them to their default speeds, or must this be done with a programmer of some kind?
drifter is offline  
Reply Like