RCU Forums - View Single Post - H-9 1/3 CAP Hardware?
Thread: H-9 1/3 CAP Hardware?
View Single Post
Old 01-15-2003 | 09:42 PM
  #5  
M3
My Feedback: (25)
 
Joined: Oct 2002
Posts: 235
Likes: 0
Received 0 Likes on 0 Posts
From: Westerville, OH
Default H-9 1/3 CAP Hardware?
Just curious, what's the minimum torque you would run on control surface servos of the 1/3 CAP?

Also, are you guys typically running dual receivers?

I have never had 1/3 scale, just 1/4, and never had gas. Looking at a ZDZ80.

Thanks!
M3 is offline  
Reply Like