RCU Forums - View Single Post - GP Cap 232
Thread: GP Cap 232
View Single Post
Old 10-21-2006 | 11:43 AM
  #179  
bubbagates's Avatar
bubbagates
My Feedback: (32)
 
Joined: May 2004
Posts: 8,635
Likes: 0
Received 2 Likes on 2 Posts
From: Elizabethtown, PA
Default RE: GP Cap 232

ORIGINAL: Kallem

Bubbagates,

I have a DA50 setup also for the CAP. I was wondering that did you go with the tail servo bay setup with your rudder? I have doubts, that if I have two digital servos on the rudder, do they fight against each other...

Because of the engine weight I need to put the servos to the rear of the plane, otherwise I am quite sure that the GC is not in place. I am planning to have the CAP as a 3D plane so I need to keep the weight as low as possible.
Like Barry said,

I have a single 5945 for the rudder and 2 5945's, one for each elevator, all in the tail. If you look at the pics of my interior setup you will see how I have things laid out and my balance came in right on the money
bubbagates is offline  
Reply Like