Michael,
Thanks for the futaba faq.
I'm working with the funtana 90 and followed the faq steps as far as assigning channels 6,7,& 8.
In MS game controller, FS1 properties, controls operate like this:

throttle operates crosshair up & dn- normal
rudder moves Z axis up & dn- ?
elevator moves crosshair L & R- ?
Aileron moves X Ro..(rotation?) up & dn-?
switch C doesn't move anything
switch G moves Z Ro... up & dn
switch E moves Y Ro... up & dn
VR(C) moves Dial & Slider up & dn

In FSOne, I have the following assigned:

throttle - axis 6
rudder - axis 5
elevator - axis 7
Ailerons - axis 4

The planes surfaces are operating correctly, but the switches don't seem to do anything. How do I set up the different flight modes, dual rates and expo, or change throws?
From reading through the big thread, it sounds like this may be possible by making the changes in my radio, but I can't set up a different model in my tx for each model in FSOne.
I have to say that the effort you, Brian, and Mike are putting forth to help us out is greatly appreciated!

griffin,