RCU Forums - View Single Post - Programming a Futaba 9C (PCM) for dual elevator servos
Thread: Programming a Futaba 9C (PCM) for dual elevator servos
View Single Post
Old 01-26-2003 | 12:34 AM
  #2  
MHawker's Avatar
MHawker
Senior Member
My Feedback: (16)
 
Joined: Mar 2002
Posts: 2,586
Likes: 0
Received 0 Likes on 0 Posts
From: San Diego, CA
Default Programming a Futaba 9C (PCM) for dual elevator servos
Wa8,

I set up my plane with two elevator servos. You have to set up the Ailevator function and use channels 1 and six (or is it 2 and six) I'll have to check my plane. It is on page 49 of your manual.... if you have it. If not, let me know and I can fax it.

I found this on Futaba's web site....

http://www.futaba-rc.com/faq/faq-9c-q512.html
MHawker is offline  
Reply Like