RCU Forums - View Single Post - Programming a Futaba 9C (PCM) for dual elevator servos
Thread: Programming a Futaba 9C (PCM) for dual elevator servos
View Single Post
Old 01-26-2003 | 01:19 AM
  #4  
Geistware
Senior Member
My Feedback: (16)
 
Joined: Apr 2002
Posts: 12,942
Likes: 0
Received 0 Likes on 0 Posts
From: Locust Grove, GA
Default Programming a Futaba 9C (PCM) for dual elevator servos
The Ailevator function uses channels 2 and 8. If you are using a 7 channel receiver, you need to mix 2 and (5 or 7)

I set up my plane with two elevator servos. You have to set up the Ailevator function and use channels 1 and six (or is it 2 and six)
Geistware is offline  
Reply Like