RCU Forums - View Single Post - Is this a good setup for the t-rex 600?
Thread: Is this a good setup for the t-rex 600?
View Single Post
Old 12-26-2006 | 01:15 PM
  #4  
expertzx
Junior Member
 
Joined: Dec 2006
Posts: 28
Likes: 0
Received 0 Likes on 0 Posts
From: Moore, OK
Default RE: Is this a good setup for the t-rex 600?
Is the ball link sizing tool and control rod setup tool necessary for me to buy?

I switched out the Hitec HS-65 MG x 3 servos with three Futaba S9252 servos and chose the Futaba GY401 gyro with 9254 digital servo.

expertzx is offline  
Reply Like