RCU Forums - View Single Post - Retract Servo Question
Thread: Retract Servo Question
View Single Post
Old 01-02-2007 | 05:12 PM
  #5  
bruce88123
 
Joined: Nov 2004
Posts: 11,703
Likes: 0
Received 1 Like on 1 Post
From: Memphis, TN
Default RE: Retract Servo Question
I found the following in the 9C Super manual

Retract servos are NOT proportional. Changing END POINT will NOT adjust the servo throw.

pg 32 of the manual.
bruce88123 is offline  
Reply Like